GGCFAD Tuning

Mic off

GGCFAD G G C F A D

Uses your microphone. Nothing is recorded or sent anywhere.

Tuning

Pitch

Normal

Strings

Detect string

A4 calibration

440Hz
  • Space Start / stop
  • 1-6 Play a string
  • A Auto detect

GGCFAD is the tuning Periphery wrote Reptile in: G G C F A D from low to high. It is Drop C with the 6th string dropped all the way to G, an octave below the 5th string.

What is GGCFAD tuning?

Start from Drop C (C G C F A D) and lower the 6th string another two and a half steps, from C to G. From standard tuning, the 6th string drops four and a half steps from E to G, and the other five strings each drop a whole step to G, C, F, A and D.

With the two lowest strings an octave apart, one finger across them plays a deep octave at any fret. Mark Holcomb calls it drop G and says the band wrote the whole of Reptile in a couple of days because the tuning inspired them so much. The low G is very loose, so you need a very heavy 6th string or a baritone guitar.

GGCFAD tuning notes

GGCFAD from the thickest string to the thinnest is G G C F A D. The frequencies are for standard pitch, A4 = 440 Hz.

StringNoteFrequency
6th (thickest)G149.00 Hz
5thG298.00 Hz
4thC3130.81 Hz
3rdF3174.61 Hz
2ndA3220.00 Hz
1st (thinnest)D4293.66 Hz

How to tune to GGCFAD

Start from standard tuning (E A D G B E) and change 6 strings:

  1. Lower the 6th string (E) 9 half steps to G.
  2. Lower the 5th string (A) a whole step to G.
  3. Lower the 4th string (D) a whole step to C.
  4. Lower the 3rd string (G) a whole step to F.
  5. Lower the 2nd string (B) a whole step to A.
  6. Lower the 1st string (E) a whole step to D.

The tuner at the top of this page is already set to GGCFAD. Press the mic button, play each open string and let it ring, then turn the tuning peg until the string lights up green. When you lower a string, go a little below the note and tune back up to it so it stays in tune.

Why guitarists use GGCFAD

  • A very deep low G, an octave below the 5th string.
  • The top five strings are the same as Drop C.
  • One finger across the bottom two strings plays an octave.

Guitarists who play in GGCFAD

Periphery found this tuning while writing Periphery IV: Hail Stan.

Mark Holcomb playing guitar on stage

Mark Holcomb

“Reptile” Periphery, 2019

Holcomb says Reptile came out of a tuning he had, G G C F A D, and the band wrote the whole song in a couple of days.

Photo: BenCohen83xx, CC BY-SA 4.0, cropped

Misha Mansoor

“Reptile” Periphery, 2019

Mansoor describes GGCFAD as Drop C with the low string dropped to G, an octave below the next string, and says the band uses it on Reptile and other 6-string songs.

Related guitar tunings

GGCFAD tuning FAQ

How do I tune to GGCFAD tuning?

Start from standard tuning (E A D G B E). Lower the 6th string (E) 9 half steps to G. Lower the 5th string (A) a whole step to G. Lower the 4th string (D) a whole step to C. Lower the 3rd string (G) a whole step to F. Lower the 2nd string (B) a whole step to A. Lower the 1st string (E) a whole step to D. The tuner on this page is already set to GGCFAD, so play each string and turn it until it lights up green.

How do I get back to standard tuning?

Raise the 6th string from G back to E. Raise the 5th string from G back to A. Raise the 4th string from C back to D. Raise the 3rd string from F back to G. Raise the 2nd string from A back to B. Raise the 1st string from D back to E. Or pick Standard under the tuner and tune each string until it turns green.

Is GGCFAD the same as Drop G?

Not quite. Holcomb calls it drop G, but Drop G on a 6-string usually means G D G C E A, Drop D tuned down three and a half steps. GGCFAD keeps the top five strings in Drop C and only drops the 6th string to G.